![]() ![]() If that's not possible, or if it's a metal trap, loosen the compression fittings with pliers or a pipe wrench. If it's a plastic trap, you can usually twist off the fittings by hand. Loosen the two compression fittings that hold the trap to the drainpipe. In a double kitchen sink, plug one drain with a wet rag while plunging the other side. Place a small bowl under the trap to catch any water. The trap is a U- or P-shaped pipe that's located directly beneath the sink's vertical drainpipe. If plunging doesn't dislodge the clog, you'll have to remove the trap from beneath the sink. It may take a few tries, but the clog will usually break up and flow down the drain. Refill the drainpipe with water and repeat. ![]() After three or four pressure pumps, quickly yank the plunger off the sink drain. Then, pump the handle up and down a few times, but don't break the seal with the drain. Press the rubber cup of the plunger down tightly over the drain hole. The chemicals could splash out and burn you (I don't recommend ever using chemical cleaners to clear clogs they're slow-working at best and can damage pipes). Also, never plunge a sink that had chemical cleaner poured down the drain. Failing to cover these holes greatly diminishes the air pressure of the plunger.īefore you start plunging, fill the drainpipe with water and put on goggles. And for a two-basin kitchen sink, cover one of the sink drains with a damp cloth as you plunge the other drain hole. You may find that you have to do this more than once to completely get rid of the clog.When plunging a bathroom sink, use your thumb to cover the overflow hole on the side of the sink. The water has to be hot enough to dissolve the organic matter that has built up in the drain.īoil some water in a large kettle or pot on the stove and carefully pour it down the drain. The operative word here is ‘boiling.’ Regular hot water from the sink won’t do it. If the water is still backing up or the sink is not draining, there is another clog in the line causing a blockage. Run some hot water to help get rid of any remaining gunk and to see if the clog is gone. Use the wire to fish out the hair and gunk, then put the stopper and/or pivot rod back into the drain. Find a light-duty wire, such as a metal clothes hanger or even a short length of wire that you can bend and make into a tight hook. To get that clog out, you’ll have to improvise a bit. More than likely, however, you will discover that the clog is from hair and gunk that has become tangled around the pivot rod or in the vicinity of the rod once you have removed it. If this is the reason for your clog, you may also want to buy a lottery ticket since bathroom sink clogs are rarely that easy – so lucky you! ![]() We recommend cleaning the stopper over a trash can, so you only have to deal with it once. ![]() It is then simply a matter of untangling the hair from the stopper and cleaning the stopper before you replace it back in the drain hole along with the pivot rod. Once you remove the stopper, you may find that the source of your clog is simply that hair and gunk has built up on it. To remove the pivot rod, unscrew the pivot rod nut with your hand or a pair of pliers and slide the pivot rod out before removing the stopper. How to Fix a Bathroom Sink Clog Step #1 – Remove and clean the stopper.ĭepending on your sink setup, you may find that you can simply lift the stopper out of the drain hole opening, or you may have to remove the pivot rod first. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |